The 60 mm code describes the unthreaded case section, not the installed gap or insertion depth. The machine drawing, target position and bracket geometry establish the final probe location while the 140 mm case determines the available mounting and withdrawal envelope.

This 5.0 m probe is intended for the 5 m Proximitor Sensor only, so the matched length does not include an added extension cable. This boundary keeps the electrical length aligned with the sensor calibration.

Keep the monitor settings unchanged while checking the installed route against the 25.4 mm minimum bend radius and confirming that the ClickLoc connection is fully seated. If the reading remains unstable after the lead is supported and the connector is secure, continue through the complete matched-system diagnostic rather than treating movement alone as proof of a cable fault.

Option 02 supplies the standard ClickLoc cable without a factory-installed connector protector. Bently Nevada recommends connector protectors for increased environmental protection, so the exposed joint should use the documented protector arrangement appropriate to the installation.

The nearby probe does not establish this order code's approval status. The ending 00 is the no-approval selection, so a classified installation needs a configuration whose delivered marking and certification match the project.

The standard probe cable is specified from -52 to +177 degrees C. If the planned route can exceed that range, the route or selected component needs to change before operation rather than relying on the stainless-steel armor as thermal protection.