Yes. The 0.5 m probe lead and 4.5 m extension cable add to the required 5 m electrical length. Both connected components still need to belong to the same 3300 XL NSv system.

The unarmored construction is correct for this order code: the 00 cable-option segment specifies no stainless-steel armor. Before release to installation, compare the full nameplate and 4.5 m length with the purchase order so the shipment is accepted against the complete configuration.

Keep the probe gap and monitor settings unchanged while checking the affected ClickLoc connection, the 25.4 mm minimum bend radius and cable support. If securing those conditions does not remove the symptom, continue through the complete matched NSv chain rather than treating cable movement alone as proof that the cable is defective.

The unarmored construction does not provide mechanical wear protection. A supported path, edge protection and the 25.4 mm minimum bend radius are appropriate so abrasion and tight bending do not reach the coaxial cable.

Bently Nevada does not recommend silicone tape where the probe-to-extension-cable connection will be exposed to turbine oil. Use the documented connector-protector arrangement for that joint and confirm that the final installation provides the required environmental protection before return to service.

The connected probe does not change this cable's order code. The ending 00 is the no-approval option, so the complete installed chain needs approval selections that meet the project's area classification.