The drawing should accommodate the M30 x 2 thread, 30 mm case, lock nut and cable exit without interference. The 30 mm case is a nonstandard metric length option, so tip diameter alone is not enough to establish mechanical fit.

The 25 mm system uses a separate probe, extension cable and Proximitor Sensor, with a complete system length of 5 m or 9 m. Select the extension cable from the installed system architecture rather than treating the probe lead as the whole chain.

This exact configuration has no armor and uses the standard PFA outer jacket. Route and support the cable so it is not exposed to rubbing, sharp bends or mechanical load; if the environment requires armor, use an officially defined armored configuration instead.

The 3300 XL 25 mm system is designed for differential-expansion measurement, but the mounting method depends on the available target, expected axial movement and target shape. Confirm whether the machine uses a collar, ramp or another documented arrangement before fixing probe position.

Code 05 is the multiple-approvals option, but the actual approval markings and the site's hazardous-area requirements still need to agree. Use the label on the supplied probe and the applicable certificate scope for acceptance.

Start with the installed gap, target geometry, cable path and matched Proximitor Sensor. Published performance is referenced to a Bently Nevada AISI 4140 steel target and defined gap conditions, so those factors should be resolved before changing monitor configuration.