The 8.0 m extension cable is used with a probe lead that brings the combined length to the Proximitor Sensor total. In the common 9 m arrangement, a 1 m probe lead plus this 8 m cable completes the documented chain.

The route must maintain a minimum 25.4 mm bend radius and provide clearance for the ClickLoc connector protectors. Planning the pull path first helps avoid bending or loading the protected joints.

Code 02 supplies the standard cable with a protector for additional environmental protection at the connection. The manufacturer specifically does not recommend silicone tape where the probe-to-extension joint will be exposed to turbine oil.

With the cable isolated, the official 8 m reference values are 1.76 plus or minus 0.26 ohm for the core path and 0.53 plus or minus 0.11 ohm for the jacket path. Compare continuity and connector seating before adjusting the channel.

The official family supports electrical and physical interchangeability with non-XL 3300 5 mm and 8 mm components, but a mixed chain is limited to the non-XL system performance. The total-length and bend-radius boundaries still apply.

Share the full exact cable label, probe lead length, Proximitor total-length code and connection environment. Those details establish the 8 m cable and protector requirement without treating it as a generic extension cable.